|Euro Atoner Kit [Full Kit]|
Build your own Atoner, with the Eurorack Atoner kit.
The Do-it-yourself kit includes all the parts necessary to build a fully-featured Eurorack Atoner. This is an intermediate-level kit; you need some prior experience, and basic hand tools (flush snips, needle-nose pliers, small screwdriver, wire stripper).
Discontinued, but the last remaining kits may still be available from some of our dealers!
Harmonics are extracted from an on-board oscillator or external audio signal and outputed as audio or clock pulses. The Position knob sets the cut-off frequency, under which all frequencies will be stepped downwards along a harmonic sequence (octaves, 5ths, 3rds, etc) all the way to sub-audible clicking sounds. Thus, a scale or clock signal can be generated from a single tone.
Two CV inputs and their respective +/- Vary Amount knobs modulate the Position cut-off. The mix of the two CV inputs plus the Position knob is outputted on a CV jack, and another CV output jack provides a steady +10V clock pulse that is jumper-selectable to be a clock division of the audio output (/1, /2, /32, /64, or non-linear division).
The Eurorack Atoner consumes 60mA of power and occupies 16 H. P. of space.